RFI Emission OS-214plus Manuel de service télécharger pdf (Page 27)

TTP-244 Plus Bar Code

Printer Service Manual

4.5 Felt Fabric Replacement

Felt Fabric is located in the ribbon supply spindle. It is used to tighten the ribbon to

prevent it from getting wrinkled during printing. If the ribbon can not be tightened when

label back feeds during printing, please replace with a new felt to secure the best

printing quality. Follow the steps below to replace the felt fabric.

1. Follow the instructions in Section 4.2 to remove DC motor and DC motor fixture.

2. Remove the E-ring and washer on ribbon supply spindle.

Components of the

Ribbon Supply Spindle

3. Remove the spring cover, compression spring and spring holder.

4. Remove the spring, felt clutch and felt fabric.

5. Replace with a new felt.

Side View of the

Ribbon Supply Spindle Assembly

E Ring

Washer

Spring Cover

Compression

Spring

Spring Holder

Spring

Felt Clutch

Felt Fabric

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 39 40

Pas de commentaire

RFI Emission OS-214plus Manuel de service Page 27